Mainly these light signals are red, orange or green. Like a similar traffic light. The red color indicates a problem or a serious error in the engine and needs to be addressed promptly. Otherwise you will be faced with major accidents and issues.
Here are the 6 Important things you should know about Dashboard Lights of Vehicles.
The yellow indicates that the vehicle has an error and must be restored quickly.
However, it does not show such errors in the color. It is used to inform the driver that a specific system is active.
1. Battery light.
The battery light, Blinking for reasons. This is when the battery is not charging more than 13.5 volt per second. It might be that batteries such as cord rust, battery charging, battery starvation, as well as displaying a problem with an alternator or voltage regulator. Car will run as long as the battery is charging. It can also reduce the performance of devices such as wipers, headlamps, and flashes. At such a time, the car’s engine can not be restored. It’s better to switch off and operate the power devices like Viper, Headlamps, and Radio.You should always check the battery before you go a long journey.
Related Articles – Chevy Brakes Problems Solved
2. Brake Light
The brake system is one of the most important things in the car. So if the brake lamp lights up, it needs to be check and Fix as same time. Brake lights, hand brakes, or breaker fluids can be ignited. Therefore, first check Hand Brake (Park Brake) and fold it up. If it does not work, you can open the bonnet and turn Brake Floyd Reservoir and reduce Breakwater. If Brake Fluid is too low, it could have a severe effect on Breakaway. So fill Break Fluid as fast as possible.
As this is lit, the two most important features of the vehicle’s security features are listed. First, there is a problem with Airbags. Therefore, it is necessary to immediately check the error for an engineer. On the other hand, this occurs in seat belt faults. The seat belts are fitted with electric insulators and clasp clips, such as paper cutlery of seat belts, which are fitted properly, but they do not have the proper fitting to the switches. (If the air bag feels just like the sky and the earth, the passenger seat belts should be worn if the airbags have to be safe.) So, if this bulb comes on, check if anything in the seat belts has been trapped.
4. Cooling Light.
This bulb lights up when the engine cools down on the cooling unit, and the radiator becomes too hot when the engine is hot. The cost of damaging the engine is more than a thousand times more likely than the problem that caused the engine to overheat. If the engine is hot due to a lack of cooling, it may be sealant. In other words, it runs and the engine can be damaged and the vehicle may stop. You will have heard this in most of the vehicles in the car. This is not the case with the vehicle. Gusts were damaged, head and block, and piston rods collapsed.
Related Articles – Chevy Rear Axle Problems Solved
5. Oil light
The oil lamp can illuminate on two grounds. One engine oil low. The other is low-pressure oil. Whatever the latter case, the end result can be that the engine is interrupted by a lot of damage. If there is a heavy load on the main road, you can hear blunders from the surrounding areas with few accidents. Therefore, when this bulb is ignited, check the engine oil and fill it in. Soon, contact your mechanic.
6. Engine Check Light.
This can cause some reasons, but often due to problems with ignition, fuel or air emission problems. Also, you may be notified by the computer system about an existing error in a different system. So if your computer also has a computerized control system, take the car to the garage where you can.
Related Articles – Chevy Transmission Problems Solved
Please share 6 Important things you should know about Dashboard Lights of Vehicles. Article so Someone else can read it.