Category: Engine

Classic Car information Engine

What happens if you put Petrol and Diesel mix in the car

Many people make mistakes because of haste and ignorance. It’s a mistake to switch Diesel petrol. Diesel is not as harmful to diesel as diesel. Petrol is a highly volatile, more fuel-efficient diesel fuel. It is burned in a cylinder by a spark. But diesel is not burnt by spark itself. It should be overridden. […]

How to check Ignition Coil Failure

This article is all about “How to check Ignition Coil Failure” This device is a simple device that is similar to a transformer. This plays an important role in a vehicle’s ignition system. Petrol air mixture supplied to cylinders The spark plug must be manufactured with a voltage of 20-30 thousand volts for the purpose […]

Classic Cars Comparison – Bour Davis Cars vs Bradley Cars

Bour Davis Cars vs Bradley Cars Auto mobile Comparison

Here is Bour Davis Cars vs Bradley Cars Auto mobile Comparison which is Include details of  Bour Davis & Bradley cars Engine,Bore and Stroke, Cylinders,Gear,Breaks, and Etc.   BOUR DAVIS Louisiana Motor Car Co., Shreveport, La.   The Bour Davis Company was an American automobile manufactured from early 90’s ( 1916 until 1922 ) The […]

Fitting Chevrolet Piston Rings

Fitting Chevrolet Piston Rings : To properly fit new piston rings and Pins proceed as follows,This is Step by Step Instruction guide for Chevy Old Cars.

Fitting Chevrolet Piston Rings This article is only for Chevy Antique cars  Properly fitting each piston ring Too much stress cannot be laid upon the importance of properly fitting each piston ring.  It is safe to say that very few consider it important, and as a result loss of power—badly carbonized valves and pistons and […]

Removing and Fitting Chevrolet Piston

Removing and Fitting Chevrolet Piston : How to remove Piston from Connecting Rod and Fitting Pistons Steps by step Instruction guide for Chevy Old Models.

This article is all about Removing and Fitting Chevrolet Piston This article is ONLY FOR CHEVROLET OLD CARS ( ANTIQUE MODELS )    Removing Piston from Connecting Rod   Raise the piston ring and insert a table knife  or hack saw blade. As the knife is slipped back of the ring and guided around the […]

Fitting Crankshaft Main Bearings

Fitting Crankshaft Main Bearings,End Play in Crankshaft,Fitting Crankshaft Main Bearings With an Aligning Reamer and Installation of engine bearings.

Fitting Crankshaft Main Bearings This article is only for Chevy Old Models  After the three upper halves of the bearings have been fitted Install the crankshaft Smear a thin coat of Prussian Blue on each bearing surface of the crankshaft. Place the thin metal shims between the upper and lower bearing caps. Replace all three […]

Fitting Crankshaft Main Bearings Upper Halves 

Fitting Crankshaft Main Bearings Upper Halves,Chevy crankshaft installation tips,properly fit crankshaft bearings Motor assembly & Fix issues.

Fitting Crankshaft Main Bearings Upper Halves  ( This article is only about Chevrolet Old Model cars )  To properly fit crankshaft bearings the motor assembly should be removed from the frame. Remove the cylinder head, pistons and connecting rods,  push rods and crankshaft gear. Turn the cylinder block upside down either on a bench, on […]